ASTM D1654-08(2016)描述了高性能有机涂料的测试程序和性能要求，这类涂料适用于建筑产品(铝合金型材和板材)。

ASTM D1654英文版本（节选）

1. Scope

1.1 This test method covers the treatment of previously painted or coated specimens for accelerated and atmospheric exposure tests and their subsequent evalsuation in respect to corrosion, blistering associated with corrosion, loss of adhesion at a scribe mark, or other film failure.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

2. Referenced Documents (purchase separately)

ASTM Standards

B117 Practice for Operating Salt Spray (Fog) Apparatus

D610 Practice for evalsuating Degree of Rusting on Painted Steel Surfaces

D714 Test Method for evalsuating Degree of Blistering of Paints

D822 Practice for Filtered Open-Flame Carbon-Arc Exposures of Paint and Related Coatings

D870 Practice for Testing Water Resistance of Coatings Using Water Immersion

D1014 Practice for Conducting Exterior Exposure Tests of Paints and Coatings on Metal Substrates

D1735 Practice for Testing Water Resistance of Coatings Using Water Fog Apparatus

D2247 Practice for Testing Water Resistance of Coatings in 100 % Relative Humidity

D2803 Guide for Testing Filiform Corrosion Resistance of Organic Coatings on Metal

D4141 Practice for Conducting Black Box and Solar Concentrating Exposures of Coatings

D4585 Practice for Testing Water Resistance of Coatings Using Controlled Condensation

D4587 Practice for Fluorescent UV-Condensation Exposures of Paint and Related Coatings

D5894 Practice for Cyclic Salt Fog/UV Exposure of Painted Metal, (Alternating Exposures in a Fog/Dry Cabinet and a UV/Condensation Cabinet)

D6695 Practice for Xenon-Arc Exposures of Paint and Related Coatings

D7087 Test Method for An Imaging Technique to Measure Rust Creepage at Scribe on Coated Test Panels Subjected to Corrosive Environments

E3 Guide for Preparation of Metallographic Specimens

G85 Practice for Modified Salt Spray (Fog) Testing

G87 Practice for Conducting Moist SO2 Tests